Features
- POWERFUL JUMP STARTER- Say goodbye to the giant car jump starter and this light weight jump starter is enough to satisfy you. You can only start 12V vehicles (Works for 0.6-2.0L Gas Engines) in seconds with a maximum current of 400A. It is suitable for your automobile, motorcycle, boat, RV and snowmobile.
- MULTI-FUNCTION- Suitable for all kinds of outdoor activities, car emergency start, SOS for help. With car auto 12V starter, portable charger and built-in LED flashlight,no matter what case you are in,especially for adventure,outdoor, daily, emergency, travel, high and low temperature(-20Ā°c to 60Ā°c), it can offer you significant help.
- BUILT-IN LED FLASHLIGHT – There are four modes of the LED: illumination, strobe and SOS, warning signal for additional safety, protection and emergency. So you don’t need to worry when you are in your way in the dark or in other situations. The LED light has 4 modesĀ Ā
- AS A CHARGER – This product can not only be a car jump starter but also supports multiple output types to recharge cell phone, psp, mp4, tablet.
- SAFETY PROTECTON READY WHENEVER – Short circuit and overcharge protection are protected against overloading of the output stage by suitable electronic switching. It is being prepared to provide you security whenever you use it!
- MULTIFUNCTIONAL CAR BATTERY BOOSTER: Not just a car battery charger, XINCOL S6 portable car jump starter is equipped with LED light, safety hammer and compass. The sharp stainless steel safety hammer can shatter vehicle windows in an emergency. A accurate compass can help you find your way home when get lost in the wild.
Specifications:
- Battery Capacity: 7500mAh
- Output: 5V/2A, 12V Jump Start
- Input: 5V/1A
- Full Charging Time : 7 hours
- Charge mode: CC/CV 15V/1A
- USB output: 5V/1A
- Start Current: 200A
- Peak Current: 400A
- Working Life: 1000 cycles
- Product Size: 160*70*18mm
- Product Weight: 700g
Package Contents:
- 1*Car Jump Starter
- 1*Jump Clamp
- 1*Car Charger
- 1*4 in 1 Mobile Phone Cables
- 1*User Manual
Operation Steps:
1. Correctly connect clamps with battery terminals.
2. Make sure the power of jump starter is at least 75%;Connect the clamps to EC5 pocket.
3. Start the engine.
4. Pull the clamps out off the jump starter.
Kindly Note:Ā
Don’t start any engine that exceeds the maximum displacement the jump starter can bear, or it will cause serious damage to the jump starter.
The jump starter will perform best when its battery is fully charged. If less than 25% charged, it may not be able to start your engine.
Do not crank the engine for more than 4 seconds. Allow the jump starter to cool down for at least 30 seconds to 1 minute after each start.
